Eurosec Pr5208 Rev1.0 User How To Do This#

This training manual is published and distributed on the basis that the publisher is not responsible for the results of any actions taken by users of information contained in this training manual based on the information contained in this manual nor for any error in or omission from this manual. For example, the products referred to in this publication are improved continually through further research and development and this may lead to information contained in this manual being altered without notice. Information Go to page/chapter or appendices for more information Show caution risk of damage to equipment and mild personal injury Warning may lead to personal injury 2 DISCLAIMER Every care has been taken by the staff of Steinsvik AS in compilation of the data contained herein and in verification of its accuracy when published, however the content of this training manual is subject to change without notice due to factors outside the control of Steinsvik AS and this manual should therefore be used as a guide only. Consult the NeoVision or Vision user manual for the complete description of navigation and configurations.6 1.1 Symbols The symbols used in this user manual, and their respective meaning, are explained below.

When the camera system is in storage and not in use, it will not pose any threat with regards to pollution. The underwater camera with depth sensor contains a small amount of glycol. Orbit-bracket for ring, mast and winch bracket Bolts, nuts, screws and washers. 3.2 Waste information PSU, winch and camera house are classified as E-waste Camera house consist mainly of POM, with small amounts of stainless steel.

Winch strength: The winch has a built-in load protection and is set to lift 10 kg at sea. These do not normally come in contact with the net, but if they are not fastened properly or if they come lose, they may pose a risk of wear and tear on the net (50-80 cm above water surface) 3. Suspension on the cage edge: The Orbit bracket for ring placed on the cage edge is made out of strong aluminium and secured with stainless steel bolts and screws. However, if the camera is not retrieved after a while, or if it under pressure from the lift-up or other equipment, this can cause wear and tear on the net. The camera s suspension rope breaks: The camera is designed with no sharp edges, so it poses no risk for holes or wear on the net/cage, even if it sinks to the bottom of the cage. The camera system does not consist of any parts that may, under normal conditions, cause damage to the net, ropes or any other parts of the plastic or steel cage construction.

Eurosec Pr5208 Rev1.0 User How To Do This

Attachment for mast/psu Attachment for Multiwinch Figure 5 Bracket with small clamp Figure 6 Bracket with large clamp Table 5 Specifications Bracket for ring Specifications Material Weight Dimensions (WxHxD) Aluminium and stainless steel 7,82 kg 315 x 502 x 553 mm15 4.6 Antenna and mast The antenna sends data from the PSU to the barge. Orbit-bracket for ring is delivered with a large and a small bottom clamp to accommodate most of the cages in today s market. See chapter 5.2 for a description on how to do this.

Table 6 Specifications Antenna and Mast Specifications Antenna Mast Material POM-C (white) Aluminium Dimensions (WxHxD) 98 x 325 x 98 mm 1500 x 40 mm Temperature range -20 C C N/A Power supply 24 V, 0,5 A (12 W), max 5,5 W N/A Humidity during 5-95% operation condensation N/A Maximum power consumption 5 W N/A Weight (kg) 1,63 Figure 7 Antenna and mast17 4.9 Pulleyblock 18 mm Specifications Table 9 Specifications - Pulleyblock Material Nylon and stainless steel Figure 11 Pulleyblock 4.10 Camera cable Steinsvik s camera cable transfer all signals from the PSU to the camera. For fibre facilities the same aluminium pipe is used for mast to attach the fibre equipment. For wireless facilities, the antenna is attached to the aluminium pipe on arrival. For more information regarding mounting and installation, see next chapter.

Standard lengths for cages are: - 120M cage: 80M - 160M cage: 100M - 200M cage: 120M When using steel cages, the standard delivery is the size of the cage x2 (ie. The counterweight adjust the winchrope according to the movement of the cage. The rope is held tight by the counterweight located outside of the cage, on the oposite end of where the winch is placed. To ensure the best possible utilisation of the system, the recommended length of the cable is diagonally from the winch to the bottom of the cage on the opposite side Rope Orbit XXXM Rope Orbit-XXXM can be delivered in many different lengths, all adjusted to the cage in which it is to be used at. It is delivered either as a blue cable or a black cable where the black cable is enhanced with Kevlar on the outside, while the blue is not enclosed in Kevlar.

The Orbit-351 and the Orbit-310 are reliable cameras that provides good visibility on the facility and specific parts of the facility Orbit-310 With careful installation of the Orbit-310, you will gain maximum advantage of the camera. More details about mounting is explained in chapter Surveillance camera Steinsvik also supplies several surveillance cameras. This might take some time to do properly, but it is worth spending some time on it in order to save much time at a later stage. The rope is to be winded out so that all white and blue lines of the rope are parralell. The user will have a very slow experience trying to control the winch if the rope have not been installed correctly.

The sensors are not included in the standard delivery and must be ordered separately. It can be connected to dome cameras and has the possibility of connecting to sensors. The cabinet receive and transmit the signals given from the gamepad to the camera. The software allows for control of the camera20 4.13 Fibre receiver cabinet The Orbit-502 IP Receiver cabinet is the receiving cabinet for fibre installations on the barge. In addition to manual control, the camera can be pre-set to fixed positions via the software.

Eurosec Pr5208 Rev1.0 User Manual